2-3/8" Square Galvanized Steel Fence Post Cap

2-3/8 Inch Square Galvanized Steel Fence Post Cap

This 2-3/8 inch square galvanized steel fence post cap corresponds to a 2.375 inch nominal profile and is listed at approximately 0.07 kg per piece. It is intended for compatible square posts in fencing, gates, repairs, and fabricated assemblies. The fractional size must be kept separate from 2-1/2 inch inventory because the 0.125 inch difference can determine whether installation succeeds.

Published Product Reference

Use the 2.375 Inch Decimal

Write both 2-3/8 and 2.375 inches on drawings, sample tags, and carton labels. Measure both post sides with the final coating applied and note rounded corners, weld seam, and end deformation. Approve engagement depth and clearance on the exact tube. Do not substitute a 2.500 inch cap without a documented dimensional and retention review.

Control Fractional Sizes on Site

Assign the cap by fence elevation, gate opening, repair zone, or fabricated assembly. If 2-3/8 and 2-1/2 inch square posts appear in the same project, use separate bins and material codes. Confirm that rails, hinge work, or internal reinforcement do not block seating. The cap is not proof of post strength or foundation adequacy.

Match the Final Coating Build

State the required galvanized process and any powder-coated finish. Zinc and powder buildup may be significant relative to the 0.125 inch difference between neighboring nominal sizes. Approve color, gloss, appearance, and repair method, then fit-test the finished sample. Avoid blanket rust-proof or lifetime claims that are not part of the accepted quotation.

Label Fractions and Decimals

Print 2-3/8 IN / 2.375 IN and SKU EONE-FPC-SQ-2375 on inner and outer packaging. Avoid handwriting that can be mistaken for 2-1/2. Establish count, separators, carton weight, pallet zone, finish, and lot. When neighboring sizes ship together, place them in physically divided and clearly documented pallet locations.

Receiving and Installation Check

Receiving staff should verify the fractional and decimal identity, two side dimensions, corner fit, approximate mass, coating, count, and lot. Test a representative cap on the approved 2.375 inch nominal post group. Retain a sample and isolate any distorted part rather than forcing it over the tube.

2-3/8 Inch Square Cap RFQ

Send tube measurements in decimals, quantity, finish, retention, size-separation rules, destination, and required date. Eone Industry can arrange samples, bulk production, inspection, and sea or air door-to-door delivery.

Surface treatment options: Pre-galvanized / Hot Dip Galvanized / Powder Coated. Confirm the required finish, color, gloss, coating build, touch-up method, and final fit allowance before production. These options should be selected in the RFQ instead of treated as interchangeable stock finishes.