1-1/2" Square Galvanized Steel Fence Post Cap

1-1/2 Inch Square Galvanized Steel Fence Post Cap

This 1-1/2 inch square galvanized steel fence post cap is a compact cover for compatible square tubes used in light fence sections, small gates, railing components, repairs, and distributor hardware stock. The current listing references an approximate mass of 0.04 kg per piece. Small square caps should be approved on the actual tube because corner radius and seam position can prevent a nominally correct item from seating.

Published Product Reference

Measure Two Axes and Four Corners

Check the tube width on both axes and at several positions near the end. Record corner radius, weld seam, burrs, flare, coating, and any twist. Define the cap's internal clearance and skirt engagement. Trial fit the finished cap without striking one corner down first, which can rack the skirt or damage the galvanized surface.

Assign Small Caps by Assembly

Identify whether the cap is for a post, rail end, small gate frame, repair, or fabricated display. Confirm adjacent welds, brackets, and rails leave room for installation. The cap finishes an open end but does not strengthen an undersized tube, replace a structural connection, or serve as a handhold, step, lifting eye, or tie-off point.

Specify the Required Surface

State pre-galvanized, galvanizing after fabrication, or powder coating over galvanized steel in the RFQ. Added coating can affect a close square fit. For powder-coated supply, approve color, gloss, texture, and touch-up method. Do not infer a corrosion-life warranty from the word galvanized without written coating, exposure, inspection, and maintenance conditions.

Prevent Mixing With Round Hardware

Use labeled inner bags and divided cartons so this 1-1/2 inch square item is not mixed with round caps or nearby square sizes. Set bag count, carton quantity, barcode, finish mark, and lot. Protect corners from denting and surface rub. Keep one accepted cap with the replenishment record for later warehouse checks.

Receiving and Installation Check

At receiving, verify both cap dimensions, diagonals, corner form, approximate weight, coating, SKU, count, and labels. Fit-check a representative piece on the approved tube before releasing stock to crews. Isolate distorted caps and document the accepted retention method, including any required coating repair after drilling, crimping, or welding.

1-1/2 Inch Square Cap RFQ

Send measured tube width, corner details, quantity, finish, retention, packing, destination, and date. Eone Industry can coordinate fit samples, production, inspection, related hardware, and air or sea door-to-door freight.