1-1/2" Round Galvanized Steel Fence Post Cap

1-1/2 Inch Round Galvanized Steel Fence Post Cap

This compact 1-1/2 inch round galvanized steel fence post cap covers a compatible small round post end in fence repairs, light perimeter work, fabricated rail sections, and distributor hardware programs. Its listed approximate mass is 0.03 kg per piece. Because small caps are often stored beside close nominal sizes, fit approval and package identification should be completed before a production quantity is released.

Published Product Reference

Confirm a Small-Diameter Fit

Measure the post outside diameter at several points with the installed coating included. Check for seam height, ovality, burrs, flare, and damage at the cut. Do not rely only on the 1-1/2 inch name, because trade descriptions and measured tube dimensions can differ. Approve the internal clearance, skirt engagement, and retention method with the actual project post or a controlled sample.

Plan Repair and Light Fence Use

Use this size only where the post schedule or measured repair member calls for it. Identify whether the cap serves a line post, rail end, small gate frame, display section, or replacement inventory. Confirm adjacent brackets and rails will not block seating. This cap finishes the open end; it does not increase post capacity or correct an undersized fence member.

Define the Galvanized Surface

State whether the order requires pre-galvanized steel, galvanizing after fabrication, or powder coating over a galvanized base. These finishes can change appearance, lead time, and clearance. Supply color and gloss when coating is requested. Galvanized material should not be described as maintenance-free or corrosion-proof without an agreed coating system, environment, inspection plan, and written warranty terms.

Keep Small Caps Separated

Specify pieces per inner bag, bag label, carton quantity, barcode, lot mark, and finish. Separate the 1-1/2 inch caps from neighboring sizes during picking and installation. Use packing that limits edge distortion and coating abrasion. Count by sealed inner pack where practical, and retain an approved sample at the warehouse for future replenishment checks.

Inspect Before Crew Distribution

At receiving, verify nominal size, approximate weight reference, cap shape, formed edge, coating, count, and labels. Trial fit a representative sample without uncontrolled hammering. Isolate dented, distorted, or heavily abraded pieces. Record the accepted lot and post source so a later mixed-size order can be checked against the same fit decision.

1-1/2 Inch Round Cap RFQ

Send measured post OD, quantity, finish, attachment method, packing, destination, and required date. Eone Industry can coordinate a fit sample, bulk production, matched hardware, and sea or air door-to-door freight after the cap and post interface is approved.